Your shopping cart is empty!
10” x 8” plastic sheet used to protect the machines’ flatbed table during the cutting process.
0 reviews / Write a review
Swarf Extractor to fit the spindle housing on the GEM-FX, FX4, FX5, RX, RX4, TX and RX5. Ready ..
Standard 11/64th brass cutter knob (left hand thread)...
Replacement Acetyl Nose Cones used to regulate the depth of cut when deep engraving, available..
Membrane Keypad, only suitable fof all U-MARQ machines except GEM-1, GEM-2 and Universals witho..
Stainless steel Vernier Spring Clip, suitable for all U-MARQ engraving machine spindles...
General purpose 2mm wrench...
General purpose 3mm wrench...
Replacement spindle drive belt for the GEM-RX, FX, TX, ZX and VX4 series of machines...
Acetyl Vernier and Nose Cone for use to control the depth when deep engraving. This accessory only f..
Brushless Spindle Motor for the GEM-RX, GEM-RX4, GEM-FX, TX, ZX and GEM-FX4 only. It is advisab..
Replacement Spindle for the U-MARQ GEM-FX, GEM-TX, GEM-ZX, GEM-RX and GEM-VX4 series of en..
High quality replacement spindle bearings for the U-MARQ GEM-RX, GEM-FX, GEM-TX, GEM-ZX and GEM..
The GEM Spindle Spanner is used to hold the spindle whilst removing the cutter holder...
Balanced sprung cutter knob for use with diamond cutters, gives a lighter cut. This product can..
Switch Mode Power Supply, suitable for all USB GEM controllers except the GEM-CX...
Replacement stepper motor for "X", "Y", "Z" and "U" axe..
Plasic coated Jig Pins to fit Multi Purpose Jig Set AC-00185 only. Sold and packaged in pa..
11/64th x 6.5" conical drag diamond, general purpose for use with all metals, available in two sizes..
Solid Micrograin carbide cutter 11/64'' x 6.50'' for general use on plastics an..
To be used for glass engraving and creating cutouts on precious metals...
Replacement diamond cutter and arm for use with the inside ring engraver, available in standard 120&..